![]() Remove the memory module from your iMac as shown below:.Pull the two levers on each side of the memory compartment to eject the memory module that's already installed:.There should be a slight click when the memory has been seated correctly. ![]() Don't use the DIMM ejector clips to push in the DIMM, as this can damage the SDRAM DIMM. After you've inserted it, press the DIMM up into the slot with your thumbs.Insert your RAM SO-DIMM into the bottom slot, keeping in mind the orientation of the keyed SO-DIMM:.Move the DIMM ejector clips to their fully open position:.Using a Phillips screwdriver, remove the RAM access door on the bottom of the iMac and set it aside:.After you've inserted it, press the DIMM up into the slot.Insert your new or replacement RAM SO-DIMM into the empty slot, noting the orientation of the keyway of the SO-DIMM as shown above.If you're replacing a memory module, untuck the tab and pull it to eject any installed memory module: Untuck the tab in the memory compartment.Using a Phillips screwdriver, remove the RAM access door in the bottom of the computer:.Tuck the tabs above the memory DIMMs and reinstall the memory access door:Īfter your iMac has cooled down, follow these steps:. ![]() There should be a slight click when the memory has been seated correctly:
0 Comments
Leave a Reply. |